/*

   Version: MPL 1.1/GPL 2.0/LGPL 2.1

   The contents of this file are subject to the Mozilla Public License Version

   1.1 (the "License"); you may not use this file except in compliance with

   the License. You may obtain a copy of the License at

   http://www.mozilla.org/MPL/

   Software distributed under the License is distributed on an "AS IS" basis,

   WITHOUT WARRANTY OF ANY KIND, either express or implied. See the License

   for the specific language governing rights and limitations under the License.

   The Original Code is the Open Hardware Monitor code.

   The Initial Developer of the Original Code is 

   Michael Möller <m.moeller@gmx.ch>.

   Portions created by the Initial Developer are Copyright (C) 2010-2011

   the Initial Developer. All Rights Reserved.

   Contributor(s):

   Alternatively, the contents of this file may be used under the terms of

   either the GNU General Public License Version 2 or later (the "GPL"), or

   the GNU Lesser General Public License Version 2.1 or later (the "LGPL"),

   in which case the provisions of the GPL or the LGPL are applicable instead

   of those above. If you wish to allow use of your version of this file only

   under the terms of either the GPL or the LGPL, and not to allow others to

   use your version of this file under the terms of the MPL, indicate your

   decision by deleting the provisions above and replace them with the notice

   and other provisions required by the GPL or the LGPL. If you do not delete

   the provisions above, a recipient may use your version of this file under

   the terms of any one of the MPL, the GPL or the LGPL.

 */

 using System.Globalization;

 using System.Text;

 namespace OpenHardwareMonitor.Hardware.LPC {

   internal class NCT677X : ISuperIO {

     private readonly ushort port;

     private readonly byte revision;

     private readonly Chip chip;

     private readonly float?[] voltages = new float?[9];

     private readonly float?[] temperatures = new float?[3];

     private readonly float?[] fans = new float?[0];

     // Hardware Monitor

     private const uint ADDRESS_REGISTER_OFFSET = 0x05;

     private const uint DATA_REGISTER_OFFSET = 0x06;

     private const byte BANK_SELECT_REGISTER = 0x4E;

     private byte ReadByte(ushort address) {

       byte bank = (byte)(address >> 8);

       byte register = (byte)(address & 0xFF);

       Ring0.WriteIoPort(port + ADDRESS_REGISTER_OFFSET, BANK_SELECT_REGISTER);

       Ring0.WriteIoPort(port + DATA_REGISTER_OFFSET, bank);

       Ring0.WriteIoPort(port + ADDRESS_REGISTER_OFFSET, register);

       return Ring0.ReadIoPort(port + DATA_REGISTER_OFFSET);

     } 

     // Consts 

     private const ushort NUVOTON_VENDOR_ID = 0x5CA3;

     // Hardware Monitor Registers    

     private const ushort VENDOR_ID_HIGH_REGISTER = 0x804F;

     private const ushort VENDOR_ID_LOW_REGISTER = 0x004F;

     private const ushort VOLTAGE_VBAT_REG = 0x0551;

     private readonly ushort[] TEMPERATURE_REG = 

       { 0x150, 0x250, 0x27, 0x62B, 0x62C, 0x62D };

     private readonly ushort[] TEMPERATURE_HALF_REG = 

       { 0x151, 0x251, 0, 0x62E, 0x62E, 0x62E };    

     private readonly ushort[] TEMPERATURE_SRC_REG = 

       { 0x621, 0x622, 0x623, 0x624, 0x625, 0x626 };

     private readonly int[] TEMPERATURE_HALF_BIT = { 7, 7, -1, 0, 1, 2 };

     private readonly ushort[] VOLTAGE_REG = 

       { 0x20, 0x21, 0x22, 0x23, 0x24, 0x25, 0x26, 0x550, 0x551 };

     private readonly ushort[] FAN_RPM_REG = 

       { 0x656, 0x658, 0x65A, 0x65C, 0x65E};

     private readonly int minFanRPM;

     private enum TemperatureSource : byte {

       SYSTIN = 1,

       CPUTIN = 2,

       AUXTIN = 3,

       SMBUSMASTER = 4,

       PECI0 = 5, 

       PECI1 = 6, 

       PECI2 = 7,

       PECI3 = 8,

       PECI4 = 9,

       PECI5 = 10,

       PECI6 = 11,

       PECI7 = 12,

       PCH_CHIP_CPU_MAX_TEMP = 13,

       PCH_CHIP_TEMP = 14,

       PCH_CPU_TEMP = 15,

       PCH_MCH_TEMP = 16, 

       PCH_DIM0_TEMP = 17,

       PCH_DIM1_TEMP = 18,

       PCH_DIM2_TEMP = 19,

       PCH_DIM3_TEMP = 20

     }

     public NCT677X(Chip chip, byte revision, ushort port) {

       this.chip = chip;

       this.revision = revision;

       this.port = port;

       if (!IsNuvotonVendor())

         return;

       switch (chip) {

         case LPC.Chip.NCT6771F:

           fans = new float?[4];

           // min value RPM value with 16-bit fan counter

           minFanRPM = (int)(1.35e6 / 0xFFFF);

           break;

         case LPC.Chip.NCT6776F:

           fans = new float?[5];

           // min value RPM value with 13-bit fan counter

           minFanRPM = (int)(1.35e6 / 0x1FFF);

           break;        

       }

     }

     private bool IsNuvotonVendor() {

       return ((ReadByte(VENDOR_ID_HIGH_REGISTER) << 8) |

         ReadByte(VENDOR_ID_LOW_REGISTER)) == NUVOTON_VENDOR_ID;

     }

     public byte? ReadGPIO(int index) {

       return null;

     }

     public void WriteGPIO(int index, byte value) { }

     public Chip Chip { get { return chip; } }

     public float?[] Voltages { get { return voltages; } }

     public float?[] Temperatures { get { return temperatures; } }

     public float?[] Fans { get { return fans; } }

     public void Update() {

       if (!Ring0.WaitIsaBusMutex(10))

         return;

       for (int i = 0; i < voltages.Length; i++) {

         float value = 0.008f * ReadByte(VOLTAGE_REG[i]);

         bool valid = value > 0;

         // check if battery voltage monitor is enabled

         if (valid && VOLTAGE_REG[i] == VOLTAGE_VBAT_REG) 

           valid = (ReadByte(0x005D) & 0x01) > 0;

         voltages[i] = valid ? value : (float?)null;

       }

       for (int i = 0; i < TEMPERATURE_REG.Length; i++) {

         int value = ((sbyte)ReadByte(TEMPERATURE_REG[i])) << 1;

         if (TEMPERATURE_HALF_BIT[i] > 0) {

           value |= ((ReadByte(TEMPERATURE_HALF_REG[i]) >>

             TEMPERATURE_HALF_BIT[i]) & 0x1);

         }

         TemperatureSource source = (TemperatureSource)

           ReadByte(TEMPERATURE_SRC_REG[i]);

         float? temperature = 0.5f * value;

         if (temperature > 125 || temperature < -55)

           temperature = null;

         switch (source) {

           case TemperatureSource.CPUTIN: temperatures[0] = temperature; break;

           case TemperatureSource.AUXTIN: temperatures[1] = temperature; break;

           case TemperatureSource.SYSTIN: temperatures[2] = temperature; break;

         }

       }

       for (int i = 0; i < fans.Length; i++) {

         byte high = ReadByte(FAN_RPM_REG[i]);

         byte low = ReadByte((ushort)(FAN_RPM_REG[i] + 1));

         int value = (high << 8) | low;

         fans[i] = value > minFanRPM ? value : 0;

       }

       Ring0.ReleaseIsaBusMutex();

     }

     public string GetReport() {

       StringBuilder r = new StringBuilder();

       r.AppendLine("LPC " + this.GetType().Name);

       r.AppendLine();

       r.Append("Chip ID: 0x"); r.AppendLine(chip.ToString("X"));

       r.Append("Chip revision: 0x");

       r.AppendLine(revision.ToString("X", CultureInfo.InvariantCulture));

       r.Append("Base Adress: 0x");

       r.AppendLine(port.ToString("X4", CultureInfo.InvariantCulture));

       r.AppendLine();

       if (!Ring0.WaitIsaBusMutex(100))

         return r.ToString();

       ushort[] addresses = new ushort[] { 

         0x000, 0x010, 0x020, 0x030, 0x040, 0x050, 0x060, 0x070,

         0x100, 0x110, 0x120, 0x130, 0x140, 0x150, 

         0x200,        0x220, 0x230, 0x240, 0x250,

         0x300,        0x320, 0x330, 0x340, 

         0x400, 0x410, 0x420,        0x440, 0x450, 0x460, 

         0x500,                             0x550, 

         0x600, 0x610 ,0x620, 0x630, 0x640, 0x650, 0x660, 0x670, 

         0xA00, 0xA10, 0xA20, 0xA30,        0xA50, 0xA60, 0xA70, 

         0xB00, 0xB10, 0xB20, 0xB30,        0xB50, 0xB60, 0xB70, 

         0xC00, 0xC10, 0xC20, 0xC30,        0xC50, 0xC60, 0xC70,

         0xD00, 0xD10, 0xD20, 0xD30,        0xD50, 0xD60, 

         0xE00, 0xE10, 0xE20, 0xE30, 

         0xF00, 0xF10, 0xF20, 0xF30};

       r.AppendLine("Hardware Monitor Registers");

       r.AppendLine();

       r.AppendLine("       00 01 02 03 04 05 06 07 08 09 0A 0B 0C 0D 0E 0F");

       r.AppendLine();

       foreach (ushort address in addresses) {

           r.Append(" ");

           r.Append(address.ToString("X3", CultureInfo.InvariantCulture));

           r.Append("  ");

           for (ushort j = 0; j <= 0xF; j++) {

             r.Append(" ");

             r.Append(ReadByte((ushort)(address | j)).ToString(

               "X2", CultureInfo.InvariantCulture));

           }

           r.AppendLine();

       }

       r.AppendLine();

       Ring0.ReleaseIsaBusMutex();

       return r.ToString();

     }

   }

 }